Go back to your sleeve puller idea just go with heavier matl. Your plate across bottom of sleeve needs to be 3/4 or even 1 inch thick and fit the sleeve properly.It is best if you take some dimemsions and get pc. that goes on bottom of sleeve machined with a step in it to go inside sleeve and keep it centered.Drill hole in center of it for at least a 1 inch unf grade 5 or better pc, of threaded rod. On the top side you just need a suitable sized pc. of schdule 40 pipe that sleeve o.d. will clear. Probably 4 1/2 or 5 inch for a D17 sleeve ? On top of the pipe another pc. of 3/4 or 1 inch plate with hole for your threaded rod to go thru. Make sure you use grade 8 flat washers under your nuts so nut dont dig in.Not knocking other ideas , but welding on the inside of your sleeves has inherent hazards if you dont really watch what you are doing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.