Posted by NCWayne on November 21, 2010 at 09:55:04 from (98.21.228.96):
In Reply to: BoB Cat Bolt/W pix. posted by LOU from WI on November 21, 2010 at 00:53:47:
Instead of trying to find one with the right length and machining threads on it why not find one a little longer with a shank length a bit shorter than you need and just cut the extra threads off? Too unless the bolt itself is being used as a bearing surface then it really isn"t going to matter whether the threads go all the way to the head or not as a bearing race isn"t going to care as long as it"s help in place and not allowed to spin. About the only reason I can see to have the threads a cetrain length is to allow the nut to bottom out but this problem can be overcome by using two jam nuts locked together instead of a single nut, or if you wanted an even more sure joint then use a thin lock nut tightened against a regular jam nut.
Check out McMaster Carr"s bolt selection and I think you might find what your looking for. They have a 1" 14TPI that is 4 inches long and has a shank length that has a standard variation in length from 2 1/4 to 2 7/8. Given the application one of those bolts with any of the given shank lengths up to right at 2 3/4 ought to work just fine without doing anything but cutting off the extra thread.
If McMaster can"t "guarantee" you the shank length will be less than 2 3/4 then you can try Earnest Machine Products. Fasteners is all they do and they may be able to help you out also. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.