Posted by omahagreg on November 23, 2010 at 18:38:35 from (72.213.45.125):
Got in the shop by 6am today, as I needed to spray some laquer on some trim pieces. Laquer is nice, compared to polyurethane, because you can recoat in about 25 minutes. Finally got to the job site by 9-stone masons have MOVED into the kitchen, so I will not be working in there today. OK, that is why I finished those trim pieces-they needed to be installed and I could do them! So, later this afternoon, I am still not able to get in the kitchen. There is an open stair well which has a 7.5" radius baseboard and baseshoe. The boss hired a lumber yard to make the baseboard, but wanted me to bend the baseshoe to match. Tried the 'million saw kerf trick' on the back, but it broke before coming close! Thought I should try steam, but I DID not have a steamer set up in my shop-I do now! Here is how I made my 'poor mans lumber steamer'.
Turkey fryer for heat and pot, now that I know it works, I will be working on a proper lid for it LOL!:
3" pvc for tube-cap is NOT glued on, and I drilled a 1/4" hole to vent:
Set it up on a table, with a slope:
Here is the curved baseboard I am trying to match:
Here is my jig, with 4 1/8" alder strips glued and drying:
Got into the house at 8pm, tired but content. I hope to be able to round over my curved piece in the morning, so it matches the baseshoe! Greg
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.