I built one for my super H one day in just under four hours . I had a 7.6 footer western plow off a 3/4 ton and i put in the shop then pulled the S/H up to it and started building the mount to fit the tractor . Used 4 inch channel and some 2 1/2 x1/4 angle and some 3/8th's flat stock and with the gas axes and the mig. and drill press it was a bolt on deal . Used one of the angle cylinders for the lift and did away with the power angle as i only had the belley pump on the Super H . worked great on the flat with just 1200 lbs if hang ons on the draw bar but when ya got on a little bit of a hill ya spun out . Tryed adding three sets of wheel weights and vary little help there with the loaded tires . Then we added chains to the mix and OH MY !!!! , Then ya had a D 9 and she would move the snow . It would have been a lot easier if the S/H would have been a wide ft.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.