Oil and then put plastic over it,just dont close the plastic up completely so it dries out if it condenses water.I have put an engine on the engine stand,oiled it up and put a trash bag over it for a month or 2 before.When you take the plastic off to build it,clean it first in case there is any dust trapped by the oil. Another way Ive done is put it on the stand, set the heads on,put a couple of bolts in to hold the heads on,put the pan on with a couple of bolts and the valve covers with a couple of bolts,intake with a couple of bolts.Then if I have some paint I might paint it.If you paint it you might get some dripped onto somewhere you dont want it,but a wire brush on a grinder will knock it right off,or you could put some masking tape around the seams I guess,and where the carburetor bolts on,tape the up and anything else you dont want paint on.Then slide a plastic bag over it after the paint dries,or anything to keep the dirt off of it and out of it.A clean rubber floor mat if its big enough works even better than a plastic bag because wind wont blow it of as easy.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
