(800) 853-2651
SHOP NOW

4020 with Schwartz front end

A

Anonymous-0

Well-known Member
I have a 1965 4020 that has a Schwartz front end under it. I need to replace the tie-rods but the center steering arm is worn were the tie-rod goes through and bolts, from the old tie-rod being bad and wallowing the hole out. Would this be a John Deere part or a aftermarket part that came with the frontend? I do not see any kind of part# on it. After I get this repaired what is the proper way to align the frontend after replacing the old tie-rods with the new. Thanks for any help you may be able to provide.

Mark
 
Thanks for the reply, What's the cost and how long would it take to get? It's hay season here in Oklahoma I my need to try and get this one machined if a new one is too far off. Please get back with me and I will figure out something.

Thanks Again
Mark
 
Mark,
After new tie-rod installation,measure center of tire to tire,front of tires & rear of tires even with spindle. The distance in the rear should 1/8-1/4 greater than the front therefore you giving toe-end.
 
You must log in or register to reply here.

Similar threads

N
4020 front end alignment procedure?
Replies
2
Views
516
Cliff Nelson
C
L
Super M Wide Front - Correct type?
Replies
13
Views
1K
D Slater
D
C
1949 8N Steering tight after rebuild
Replies
3
Views
420
Bruce(OR)
B
5
Schwartz wide front?
Replies
4
Views
950
Eldon (WA)
E
H
JD 4020 Front Wheel Bearings
Replies
6
Views
490
hoosier43fan
H
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top