(800) 853-2651
SHOP NOW

IH wheels

C

caterpillar guy

Well-known Member
On a 1466 are there differences in the wedge locks that lock them to the axle shaft? If so then how do I tell the difference?
I have one wheel that the wedges only go in about 1/2 to 3/4 inch on each side and the other side they bottom on the wedge ramp in the wheel before they get tight. There are also 2 different wheel castings on this tractor one has ony 4 holes about the size of your hand in it,and the other has about a dozen of those holes/spokes in it.
 
The first Wedge lock wheels have more holes than the older, heavier wheels. On the one that does not enter the wheel properly, does it fit on the axle properly or does it only touch on the sides? You may have a wedge lock for a smaller axle.
 
Yes they are setting on the axle ok just seem to be going in to the center of the hub to far so they are past the end of the ramp in the wheel like they are not thick enough to fill the wedge.
 
You must log in or register to reply here.

Similar threads

D
Back to the Allis B govern/carburetor issue I still haven't resolved.
Replies
8
Views
428
Dave Westlund
D
super99
Wheel spacing for plowing
Replies
16
Views
630
Leroy
L
H
throttle control arm
Replies
9
Views
308
Den N Ms
D
1
allis chalmers G carburetor
Replies
1
Views
187
Janicholson
Janicholson
super99
99 Silverado door locks
Replies
11
Views
843
miangus
M
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top