Farmall & IHC Tractors Discussion Board |
Re: IHC Farmall 656
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Diesel Don on March 28, 2002 at 10:41:45 from (141.129.1.112):
In Reply to: IHC Farmall 656 posted by lanny on March 27, 2002 at 18:49:42:
It sounds to me like you have a single auxillary valve on the tractor split into two valves mounted on the loader.My gas 656 had the same set up.What I would do is get an I&T manual for it and check the proceedure for setting the detents on the tractor auxillary valves.Sounds like they are set a little low.I wouldn't recommend adjusting the relief on the loader.I added a second auxillary valve to my 656 because there is quite a bit of restriction going through all the extra piping by having to split the flow through 2 valves on the loader.I could hear the engine labor when I pulled in the auxillary to feed fluid to the loader.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|