Farmall & IHC Tractors Discussion Board |
Re: Hey, Steven@nd...
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steven@nd on October 02, 2002 at 16:02:17 from (12.15.56.61):
In Reply to: Hey, Steven@nd... posted by jal-SD on October 02, 2002 at 14:21:13:
Yep, got them 12.4x38's mounted up. They are pretty good tires! Some weather checking, but good tread, and hey, they were free! Cost me about $100 for 2 new tubes and mounting, also had one rim welded up where it was rusted through. Got a slight problem though... Only 80 pounds of compression, and webers shows 95 lbs for the distillate. I think I should have more with the step head pistons, but oh well it mows and rakes really good. Just doesn't have enough power to spin out or raise the front wheels off the ground when cultivating. Working on getting the pieces together to add power steering so it will be easier to use around the yard in tight spaces. Also, it steers a little tough with that mounted mower hanging on it. Might even go all out with distributor drive live hydralics by springtime! Oh yeah, had 37.2 hours on it last weekend and Dad was planning on using it for grinding feed this week. Getting colder here, going to change the oil this weekend to 15w-40 Rotella for the winter, probably keep that in it too. Wish it could rain, our cows are getting really hungry, Dad started feeding a bale a day a week ago already. Pasture is nothing but dirt, the wheat they grazed didn't last either. School is going good, figure I should finish in Spring of '04. Then I don't know where I'll end up, hopefully somewhere with old tractors sitting in the trees! Steven
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|