Farmall & IHC Tractors Discussion Board |
Re: fast hitch mower
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark Mitchell on September 23, 2004 at 18:14:11 from (130.20.52.161):
In Reply to: fast hitch mower posted by jwh on September 23, 2004 at 16:08:40:
I have a similar mower, judging from your description. The chain goes to the left side "Touch Control" lever, and controls the height off the ground for the mower itself. I have mine on a Super C, I use it a lot and really like it. Mine does not have any guards on it and I think it never did - it dates from a time when mfg's were not required to design for idiots. Needless to say be sure this thing is disengaged before getting on or off the tractor. Check the oil in the bearing housing for the upper and lower pullies, and it has about 12 grease zerks that I would suggest giving a shot of grease before using it. The wooden shaft that goes between the lower crank pully and the mower blade itself is (or at least was till recently) available at IH dealers. Look around and try to find the front end of the short driveshaft that goes to the PTO. On mine it was missing but it was not hard to get one fabbed up. Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|