Farmall & IHC Tractors Discussion Board |
Re: IH 706 PTO
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by PA Steve on February 08, 2005 at 13:21:51 from (204.60.75.237):
In Reply to: IH 706 PTO posted by Ginia on February 08, 2005 at 05:03:15:
The PTO setup on the 706 is independent of the main clutch. It has its own hydraulic clutch. Others mentioned that the brakes may be worn out. We rebuilt the PTO clutch on out 706 and it wasn't a bad job. You'll have to drain the transmission/hydraulic oil down past the level of the PTO housing to avoid a large oil mess. The PTO unit is heavy and bulky, so a second set of hands will be helpful when removing and re-installing it. Also, it is possible that your PTO shutoff problem is caused by the control linkage being out of adjustment. The adjustment is located where the linkage goes into the PTO housing. Maybe someone else can provide some info on how to distinguish between worn PTO brakes and linkage misadjustment. Good Luck, PA Steve
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|