Farmall & IHC Tractors Discussion Board |
Got it! Thanks, guys.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BillWV on May 20, 2006 at 19:22:03 from (129.71.136.245):
In Reply to: Help! With Super C brake job posted by BillWV on May 19, 2006 at 17:19:51:
I gently tapped with my 2-lb shop hammer, and gingerly pried with a 3-ft nail puller. :-) Actually, ground some screwdrivers thin and tapped them in sequentially until it broke loose. It was the center where the o-ring is that was holding it so tight. I assume that the notches around the perimeter are for a gear puller? Didn't have one handy or I would have tried it. Would have to take the wheel off first to have enough room. Looking forward to getting the brakes fixed now. Thanks, Bill
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|