Farmall & IHC Tractors Discussion Board |
C charging problems
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tim Mattson on October 16, 2006 at 12:10:19 from (207.91.16.162):
My 1948 Farmall C charges but not enough to keep up with the lights on. The C has a magneto and orginally had a cut-out relay. I switched to a voltage regulator but it didn't help any. With the tractor off, the battery's voltage is at 6.20, with it running at high idle its at 6.30v, and shows 5 amps on the ammeter. With the lights on dim, it drops to 6.20v and a discharge of 7 amps, and with the lights on high is goes down to 6.12 volts and a discharge of 9 amps. I've checked the grounds on the generator, regular, and instrument box and ran an extra wire back to the ground post of the battery, did the motor test on the generator, ran good, with the field grounded, then ungrounded it ran faster. I've replaced the generator brushes and adjusted the third brush to the highest setting. Any ideas? Thanks
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|