Farmall & IHC Tractors Discussion Board |
Delco Alt. 1 wire to 3 wire
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by SuperA-Tx on February 14, 2007 at 15:44:24 from (4.227.107.121):
Cousin converted my Super A to 12 volt back several years ago and used the Delco 10SI Alternator. It is wired like Image #11 on Bob's wiring diagram page, I ran all new wires. I had to put a smaller pulley on it to get it to excite but after that it works alright although I still have to rev it up sometimes to get it to excite. A week or so ago tho I was reading here that the three wire system is lots better. On Bob's site theres a diagram for Farmall Super H (image #6) that uses the Delco 10SI Alt but has the three wires. I see no differance in the two diagrams other than the extra two wires off the 1 and 2 posts on the alternator and the added "warning light". Is there a reason I couldnt just add the two wires and the warning light to my setup thus converting it to a three wire system? Would something have to be done to the Alternator other to make it work other than what I have mentioned? Plus I saw in a post where you could use a diode in place of the warning light. Can someone tell me a little more about that please. http://albums.photo.epson.com/j/AlbumIndex?u=4001561&a=30065733&f=0
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|