Posted by Hendrik from Germany on September 16, 2015 at 03:16:35 from (212.144.4.245):
Some more Pictures of FAHR machinery. The last ones...
This is a very nice farming setup, typical for the German farmer back in the 1950s. A Fahr D25N Diesel tractor pulling a FAHR hay loading trailer. The tractor has an aftermarket "Fritzmeyer" canopy, which was very popular in those days.
This picture proves that FAHR really was a big manufacturer of harvesting machinery. The machines shown in this picture could have been attached to FAHR walk-behind tractors.
This FAHR KT10D walk-behind tractor has a single cylinder two-stroke Diesel engine. As you can see, it pulls a FAHR sit-on type hay tedder.
Another picture of this setup.
FAHR horse-pulled mowers used to be very common in Germany. This one has an additional small gas engine that powered the sickle bar. This was a big relief for the horses.
At last:
FAHR pull-type combines (late 1960s) and self-propelled combines.
Now we are leving the FAHR section of the 2015 Nordhorn tractor show. We will now enter the giant section featuring DEUT tractors. I guess DEUTZ tractors are better known in the U.S. than FAHR machinery.
I hope there are some U.S. Deutz enthusiasts watching this thread. You will see pictures of the oldest Deutz tractors known to exist and of many other rare Deutz pieces!
Hendrik
This post was edited by Hendrik from Germany at 03:17:43 09/16/15.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.