Posted by notjustair on January 01, 2016 at 14:35:21 from (70.195.3.69):
It has been quite some time but I know this was discussed at some point. I have a stock tank heater that is putting volts into the water. I ran a 100 foot cord from the shed to this pen last year but it was just one boar so I used a heated bucket. The element doesn't touch the water. I never had any issues.
This year I have some feeder pigs in that pen. I threw in one of those 75 gallon recycled tire stock tanks and they have been using it all fall. I put in a brand new stock tank heater and it is shocking them. Not like electric fence level but enough to make them jump. I can tell you that the ground prong is part of it because when I unplugged the heater one came and drank. While he was drinking I plugged in just the ground prong into the cord and he got shocked. It isn't much, but I am getting residual from somewhere.
Do I test across the prongs of the tank heater or from the water to the ground? I thought it was odd when everyone was talking about it years ago, but I remember JD Seller saying something about driving in a ground rod next to each tank. Do I do that and then run the other end into the water?
What do I test to determine the fault and how do I fix it?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.