Posted by mtc005 on July 27, 2016 at 15:52:39 from (99.103.202.2):
I have had a 2003 BX2200 Kabota for 5 years. With the backhoe attachment and front loader, I have used it maybe twice a year. It has 553 hours on it. It has worked fine for about 3 hours at a time, them struggled to maintain power. An auction came up and when I loaded it onto the trailer, the nipple on the "out" side of the fuel pump cracked. I bought a fuel pump at a local parts store and it would not run ( but would try to start). I then ordered an aftermarket and had the same issue. Finally I ordering the $161.50 fuel pump from kabota, the tractor fired up and I ran it for 20 minutes. During this same period, the fuel cap failed and the center of it fell into the tank. All four nipples on the fuel tank broke off and I drilled and tapped new brass fittings into each of these. The fuel kill solenoid has been failing for years. I cut off the pin for now, and left the pigtail disconnected until the new kill solenoid comes in. It would work great when the engine was cool, but after it warmed up the kill solenoid would burn your finger if you touched it. When you place the key switch in the start mode, the pin would detract. In the run position, the pin would stay retracted. When key was in the off position, the power would shut off holding the pin inside the solenoid and a loud click could be heard as the pin sprang out to shut the fuel off. After I turned it off, it would not restart. All four nipples on the fuel tank broke off after I placed it in the auction and the fuel tank seems to produce water. I have drained and vacuumed out the fuel tank 3 times. How water continues to get in there I beyond my understanding. I didn't sell this tractor at the auction. The best bid was 5750. I saw the backhoe attachment for sale by itself for 5K and the bucket for 3K. I want to get this tractor running right. I couldn't stand to give it away. My parts (operator, parts and service manual, kill solenoid, all filters and oil, and key switch) should be in soon and I will persevere. Any thoughts would be appreciated.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
