I THINK I can say what is wrong. Your first problem started when the fu@8 years Kubotel cap vent )Which is quite complicated) failed. What you thought was stoping after it got warm was it stopped when you pulled a vacuum on the fuel tank. The fact that it sucked the center of the cap proves that. Now also the Factory KUBOTA you bought was just more pump than the first two you bought. The small vent lines there on the front of the tank were collapsed and caused the tubes to snap off. It is important to understand the fuel control solenoid circuit. There are three wires involved. One furnishes power to the PULL in coil of the solenoid. That circuit is only active when you turn the key to the START position then as you release the key to the run position power goes to another spade or coil called the hold in coil. That holds it pin back to let the unit run. When you say you experienced heat at the solenoid I am certain the hold in coil was going to ground and has probably failed by now. Sound like you are a pretty good mechanic , maybe you will get it going. I would not sell it for that either should bring 10 to 11 thousand.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.