The understanding I get as for the cleaning process, when an engine block or heads, or any component comes back from the machine shop, there will be different types of contaminants adhering to the surfaces and hiding in all the inaccessible places.
There are basically 3 types of contaminants: petroleum base, water base, and solvent base. Each one is removed by it's own base cleaner.
The petroleum base contaminants, think naturally occurring residue in an engine, oil, grease, etc. Can be cleaned with naphtha, diesel, gasoline.
Water base contaminants, grit and the glue that binds the honing stones together, left stuck to and embedded in the cylinder walls, also some detergents used in the cleaning process. This is what the soapy water goes after, pressure washing also gets down in the nooks and cranneys where the grit likes to hide.
And solvent based, gets what is left, like synthetic cutting fluids, anything else that may be left. This is in the brake cleaner, carb cleaner, lacquer thinner family.
As for ring assembly lube, I always just use motor oil. Give the rings and wrist pin a few shots before installing the ring compressor. Wipe some oil on the cylinder walls to prevent rust.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.