I was going to go the 8 volts route on an SC and DC CASE. After research on YT and a local tractor salvage parts store owner who had several people there who had been there for years, said no on the 8 volt system. Too many changes to be made with little improvement. Said one needs amps, not volts. These Guys talked from experience. Yes, it is hard to find a good 6 volt battery. I converted both tractors to 1/0 cables. From battery to starter button, and button to starter. Also put in cut -out switches, so there is no drain, as these antiques tend to set a lot. That way they are OFF! Also when displayed at county fair, they are off. Some kids gets on there and pulls the ignition switch ondead battery! I was having starting problems for a long time with both tractors. Replaced coils, wires,plugs, rotors, distributor capswent through it all. Then had starters checked and rebuilt if needed. Then had carbs cleaned and rebuilt. Not much change in starting! Actually worse on one of them. The problem was the starter buttons! These are momentary switches. Replaced them, now both start good. I tore those old switched apart. Simple spring loaded contacts inside. Burnt! That was the problem in the first place. Keep fresh fuel in them. Add a quart of that super fuel they use in small engines, 4 cycle,also add fuel stabilizer( StarTron) , and keep trickle chargers on the 6 volts. Not sure if the super fuel helps, but actually I had best luck on 6 volt batteries from local farm supply store and also from a Wal mart battery. Hope this sheds new light and good luck. By the way, should one still use lead additive in these old tractors? Its hard to find. Maybe if one was farming with them, maybe not just for show and parade.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.