When I was a kid, I always cleaned parts with gas, since it was cheap and effective, and we always had some available.
Now it scares the heck out of me! Gas can and will flash extremely easy. And if you have gas on your hands when it catches fire, what do you do then? Stick your hands in your pockets to put out the fire? At best you will lose some of the skin off of them. At worst, you will need skin grafts or even die. And if you are inside, the building will probably burn down.
The only way I would use gasoline as a parts cleaning solvent is outside, in a well ventilated area where a fire might only hurt the parts I was cleaning and the container I was using. I also would have a 5 gallon bucket of water a little distance away, to save my hands if there was any chance of gas getting on them.
I used to have a barrel with a removable top that I kept some solvent in for soaking parts. The solvent inside was a mixture of mostly diesel, but had most any other waste solvent I had added--some gasoline, some alcohol, some paint thinner, etc. It worked pretty well, but finally the barrel corroded a hole in it and leaked the contents out, making an awful mess. I don't think I will do that again.
I have had pretty good luck using diesel as a parts cleaning solvent. It won't flash and works fairly well. If I need to, I use spray carb or brake cleaner to finish the cleaning, but always do that spraying outside.
Gas is just too dangerous for this old man! If you choose to use gas, good luck!, you may need some.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.