Farmall & IHC Tractors Discussion Board |
Re: 656 intenational injector pump manual[stanadyn
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on May 10, 2007 at 17:25:09 from (75.19.120.63):
In Reply to: 656 intenational injector pump manual[stanadyne] posted by Randal Rutherford on May 10, 2007 at 16:46:22:
If ya are not experance in injection pump work then it is wise to keep your pinkies out as a twist here and a twist there can cause some of the inside pices of the engine to be on the outside in short order . As for the adjuesment on the outside of the pump ya have high and low idel and the load screw and that one best leave alone along with the high idel . And you can not tell what the pressure is just by cracking a line or two . If the engine has a miss it could be a bad injector and here again with out the proper test equipment ya ain't going to DIY it . Even with the book ya still have to have one of them test stands to set and check .
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|