Farmall & IHC Tractors Discussion Board |
Re: Super C Touch Control
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Harold Hubbard on April 19, 2002 at 18:37:05 from (216.114.175.167):
In Reply to: Super C Touch Control posted by J3nut on April 19, 2002 at 17:46:07:
The last guy glued both sides of the gasket with something indestructable. Some times a little heat, (heat gun)will help but usually it comes down to bull strength and ignorance. A very thin chisel or heavy putty knife can be tapped into the split, a little bit here, a little bit there, all the way around, and eventually it should give up. Once it starts to move, you can pry on it, but keep your tool near the outside edges. Sometimes a good shot sideways with a heavy hammer will do the trick, strike against a piece of wood or a big chunk of brass, not directly on the casting.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|