Farmall & IHC Tractors Discussion Board |
Re: Re: Super C Touch Control
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ScottyNY on April 19, 2002 at 19:20:24 from (24.169.149.69):
In Reply to: Re: Super C Touch Control posted by Harold Hubbard on April 19, 2002 at 18:37:05:
Couldn't have said it any better myself, Harold. I had the same experience as J3Nut. No end of prying, poking tapping. In my case, there was a bead of the old gasket sealer pretty much all the way around. I was able to scrape most of it away Then applied a pentrant and let it soak. Hydraulic pressure is a wonderful thing. It swelled and softened the gasket in a couple of spots so I was able to get a stiff scraper in there to pry. Once it started, it came pretty well. J3Nut, you'll need to think aggressively, without actually goin nuts on this. From your message,I suspect you don't need any reminding that you're working on cast iron (read "brittle", think "don't crack"). A brass or other "soft" hammer can also be good-again you can't go nuts with it, but it's less apt to do harm than steel. The only other thing that comes to mind is that if the head is coming off that hard, it'll take some extra work to get the old gasket and sealer off. I'd recommend tending to that before you clean up the rest as you go along, to avoid ruining good cleaning job. Best of Luck! Scotty
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|