Farmall & IHC Tractors Discussion Board |
M Remote Hydraulics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Doc on June 08, 2002 at 15:06:55 from (204.73.55.90):
I put a factory remote control valve on my M. Same as what came on the Super's and SMTA. I bought this as NOS, valve only. I think I may have it hooked into the system improperly. I ran the pressure hose from a belly pump outlet to the port on the left side of the valve (when looking from the rear), and the outlets to the rear of the tractor from the two ports which are next to each other on the rear of the valve. Problem is with the valve hooked into the system, I get no lift for the loader hooked into the belly pump outlets unless I pull the belly pump lever back and then move the control lever for the remote. This will then lift the loader which is attached to the belly pump outlets. The loader will lift when the remote valve lever is moved in either direction. The loader will not hold up no matter what position either lever is in. I have the IH manual for this valve, does not show which port the different hoses go to. Does someone have one and could give me advice on what goes where? Thanks. Doc
Follow Ups:
Home
| Forums
Today's Featured Article -
A City Guy's First Tractor - by Fred Hambrecht. After living in apartments in Atlanta for more years than I care to remember, the wife and I decided to move to the country. Humming "Green Acres is the place for me..." we purchased a 29 acre tract about 60 miles south of Atlanta. Next came the house, I could talk about that ordeal for another two weeks... But, I want to talk about my tractor! We didn't even own a lawnmower, and all of a sudden we had enough grass to feed all the starving children of the bovine world. Naturally, I talked
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|