Farmall & IHC Tractors Discussion Board |
Re: Adding transmission oil to International model
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by J in Pa on October 25, 2003 at 18:29:55 from (24.154.98.61):
In Reply to: Adding transmission oil to International model 404 posted by Willy Young on October 25, 2003 at 17:33:56:
willy, i dont know if this will help you or not. you say its a 404 international. ok, on the 404 farmall the fill for the tranny is located near the gear shift. it takes, i think a 3/4 square drive to remove it. in the rear left of the tranny case on the 404 farmall, there is a small plug, 1/4 inch drive. this is the fill level of the tranny. just add fluid from the top till it runs out the little plug in the back.. like i say, this is for a 404 farmall. i dont know if the 404 international is the same or not. take a look. it might be the same. J in Pa
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|