Farmall & IHC Tractors Discussion Board |
Re: 100/a and farmall 200/sc interchange
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by tractorsam on October 20, 2006 at 17:37:44 from (142.167.174.133):
In Reply to: 100/a and farmall 200/sc interchange posted by wegman in Mn on October 20, 2006 at 07:45:09:
First off, I think the front axle (along with its mounting casting) would bolt up but it wouldn't work anything like it should. There are some pretty major steering issues and the pivot point wouldn't be in the center of the tractor. As to the bell housing, ignoring the A and the B I think they are more or less the same. However I can't remember about the support near the steering universal joint. If it's supported on the torque tube there could be a difference, if not I'd think it should work. I don't know that this helps, tractorsam
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|