Farmall & IHC Tractors Discussion Board |
Re: farm all 200 center lift question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nat 2 on February 16, 2007 at 06:56:50 from (64.80.110.27):
In Reply to: farm all 200 center lift question posted by Tom Whitehead on February 15, 2007 at 17:15:45:
It's called a Touch Control, which will help you in your searching. Someone said it was home made, but that's not true. The Touch Control under the gas tank is factory. The BELLY BLADE is home made, but you already said that... As stated below, there are two controls and three arms. One control moves a pair of arms, and one control moves an arm on the left side. It sounds like the belly blade was hooked up to both controls so you could lift and lower each side independently. Neat. Works like a "real" road grader, except that it doesn't work :( Get yourself a can of PB Blaster or Kroil and start squirting all the pivot points for that left lever. It may be that only the linkage is rusted up and there is nothing wrong with the cylinder. You can find the IH Touch Control troubleshooting manual online at www.cleancomputes.com/Cub.
Replies:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|