Posted by SteveNH on October 01, 2008 at 07:27:25 from (149.32.192.33):
I did a lot of searching and reading though the archives in this forum and found enough information to be dangerous.
I ordered a bypass block from Saginaw to go on the touch control unit of my 1948 Super A. I am not the most knowledgeable person when it comes to hydraulics so I hope to find a little help here.
From what I read I need an open center type valve. I also read my pump is close to 5 gpm. Looking around I found a 2 spool 5 gpm open center valve. One spool is single acting and the other is double acting. Can I use something like this understanding I may need an axillary reservoir? I currently have no need for remotes but wanted to add them for future use and I wasn"t sure if I would need double or single acting and this looked like it covered all bases. I am guessing the valve has one in and one out?
It looks like a lot of people have done this so I was just seeing if what I had in mind would work or if I am way off base. You guys haven"t let me down so far!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.