Thanks for the input. I've learned quite a bit over the last few days, thanks to all of you who've replied here!
I like the idea of the bungee cord versus the hose clamp, but as power down is about the same as gravity down, I don't think I'll be too concerned. If it must be held all the way back to provide pressure to the christmas tree (which it does), is there any way to improve or adjust the linkage?
Rather than limiting the cylinders to control height, I've actually decided to weld on a pair of adjustable height brackets to the front of the mower, to which I can attach a pair of 10" swivel casters. This would allow me to control the height of the deck, but at the same time keep the deck the right height off the ground without using the hydraulics. Actually, if I power the 3-point down past the 'resting point' of the deck so equipped with casters, the 3-point will float, thus treating the deck like a floating drawbar style.
I'll have to do more research into what makes them work, but I had actually toyed with the idea of designing my own position control. Whether or not, at the end of it all, it would be cheaper than buying one aftermarket (if such a thing existed), I don't know, but when they work properly, they sure are nice to have.
I'll get the LiftAll service manual (along with the M service manual) soon, so I can repair the leaking valve. It's a little unnerving when I stop the tractor to do some side work (the other day I had a 35-gallon barrel of water on the mowing deck and was siphoning water out of it to water new trees) and the deck slowly creeps downward with clunks and groans!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
