Well, now, you've sent me back to the books (or the Case?IH online books as it were). I missed the reducer on my first pass through there. It's listed as separate part from the elbow and it's not clear from the drawings where it goes, so now I'm gonna shoot from the hip a little.
I can imagine a couple of layouts, which will depend on what the female thread at the top of the manifold is, and what you need to be clamping the pipe to at the top of the elbow.
If it's a 1" pipe thread at the top of the manifold, I can imagine a reducer with a 1" male to come out of the manifold that steps up to mate with the 1-1/4" thread of the elbow, with the pipe clamped to the top of the elbow.
The other way is if the thread on the manifold is 1-1/4". That would mean a plain 1-1/4" elbow with the reducer at the top to clamp the pipe to.
A really elegant solution (though it might mess up the geometry of fitting the pipe and having it hang right) would be an elbow threaded 1" at one end and 1-1/4 at the other, but, plumbing being what it is, I don't know that there is such a beast.
I've always said that the puzzlin' and ponderin' time that is a part of wrenchin' in the dark is some of the most satisfyin' time a fella can spend. I'll be interested in hearin' what you can find, but I would start with a good plumbing supply house.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.