Posted by Roger Tomfohrde on September 17, 2012 at 18:15:59 from (71.49.82.193):
In Reply to: Farmall 460 fast hitch. posted by Kevin B from Illinois on September 17, 2012 at 11:59:04:
Give a try like what I do. I set the hitch with the hydraulics to the mid level position. I then disconnect each side, one at a time and move the upright shaft forward to where the top arms pivot and pin them in the holes provided. One side you move just the pin and the other the whole pivot is moved in the hole. Once that is done the top shaft is lowered down all the way and now it is more like the standard hitch for getting on and off. At least you can use the fast hitch when you need it later without changeing all those parts. I myself have two of the standard hitchs from a 560 on the shop floor from parting out one and putting a fast hitch on the other 560.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.