Posted by RLP in Co. on September 29, 2019 at 20:08:34 from (174.254.194.138):
In Reply to: Tire mounting tricks posted by Grandpa love on September 29, 2019 at 05:09:38:
Mounting tires is easy; it's the dismounting that's hard. Get one of those tire hammers. You will never regret it. Put some oil on the bead of the tire, and the rim and the bead and jam the tire on the rim. Hit the bead a couple of times and you're done. I put a thin coat of vasoline on the rim, not the tire, and then silicon on the bead of the rim first. The vasoline will keep the silicon from sticking to the rim , so that the next time you change the tire, It will come off easily. It will even seal a badly damaged tire bead. It is also very slick, and makes it easier to seat the beads. Next time you demount your tire, you will see your nice clean rim without a spot of rust. If you get a little silicon on the tire, don't wipe it off. Wait till it dries and use a twisted wire wheel in a drill to take it off. It comes off very easily that way. Before I air up the tire to seat the beads, I spray wd40 all the way around the bead area. A clip on air chuck comes in handy too. Take out the valve core, so that the air flows faster. You will have to take out the valve core depressor out of the air chuck.I also have a regular clip on air chuck. Sometimes it helps to hit the tire with that big hammer on the tread while you seat the bead with the air flowing in the tire at the same time. If all else fails, I use carb cleaner, haha. That never fails!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.