Farmall & IHC Tractors Discussion Board |
Re: M carb/governor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by J3nut on September 15, 2001 at 19:12:49 from (152.163.201.62):
In Reply to: M carb/governor posted by Busch on September 15, 2001 at 12:47:08:
If "The Red's" idea doesn't fix your problem, try this. I recently had a very frustrating problem with my Super C carb that sounds like what you are describing. After rebuilding my carb it still leaked bad. The problem was the bowl gasket was not cut properly to allow the air to vent out of the bowl. Since the air could not get out, the gas would not fill up the bowl to raise the float. Lay the gasket on the fuel bowl and make sure all is ok there then turn the throttle body over and do the same with it. Mine took some substantial trimming and it was from an IH kit. Now it works like a charm. Good luck!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Listening to Your Tractor - by Curtis Von Fange. Years ago there was a TV show about a talking car. Unless you are from another planet, physically or otherwise, I don’t think our internal combustion buddies will talk and tell us their problems. But, on the other hand, there is a secret language that our mechanical companions readily do speak. It is an interesting form of communication that involves all the senses of the listener. In this series we are going to investigate and learn the basic rudimentary skills of understanding this lingo.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|