Farmall & IHC Tractors Discussion Board |
Must be overlookin it
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Joe on September 23, 2001 at 13:35:34 from (63.174.203.51):
I have been restoring a 1948 farmall H and since I recieved it in many pieces things are either changed or not fittin right. I can't get the valves set because when the rocker arm adjustment screw is turned all the way down there is still a half inch of up and down play in the pushrods. So after measuring and stewing over it I thought I'd ask you guys! Here is a list of casting numbers and measurements I have taken to possibly assist you in helping me. Block 6695 D,Head 8043 DG, Rockerarms 45036 DB, push rods are 14 9/16 inches,tappets are 2 1/4 inches long, Camshaft 43962DB, valves are T1672 Marvel A and 5 1/16 inches long and when installed in the head they stick up approx. 1 5/8 inches off the machined surface the valves have just been ground to fit the seats. Any help would be greatly appreciated. Thanks, Joe
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|