|
Farmall & IHC Tractors Discussion Board |
Re: half turn steering slop IN farmall A
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by gene bender on March 06, 2007 at 04:30:22 from (67.55.226.214):
In Reply to: half turn steering slop IN farmall A posted by Chad from Michigan on March 06, 2007 at 04:14:00:
The gear is not full circle but does have a key that is worn plus the bearing on the end of the steering shaft. Tear it down put in new bushings and seals, bearings and fill with 90wt and you will have new steering. Parts will run 50.00. Take the large nut off the front of the sector and remove the steering wheel and the shaft will screw out the front. You will have to remove the pin the axle pivots and the u-shaped bracket that acts as a stop then the whole axle can be removed then the steering box can be separated. Then with new bearings ,bushings and seals and replace the key job is complete. I have done several last few yrs always have good results.
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
