Farmall & IHC Tractors Discussion Board |
Re: stupid questions about A/Super A motor
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nat 2 on March 07, 2007 at 23:06:20 from (64.80.110.50):
In Reply to: stupid questions about A/Super A motor posted by drab cat on March 07, 2007 at 20:45:32:
The original engine was designed for gravity fuel feed. I don't think it has provisions for a fuel pump. Are you sure the fuel tank is in the "stock" location? It was probably positive ground, unless Yale was weird at the time. Most everyone was positive ground. Really doesn't matter. All that'll happen if you get it backwards is the generator won't charge until you polarize it, and then the Ammeter will read discharge when the generator is charging. Find TDC on the compression stroke for cylinder #1. Use the thumb-over-plug-hole trick, feel for whooshing air, then line up the mark on the pulley with the timing pointer on the engine. Pull the distributor cap, turn distributor until rotor points at #1 tower on distributor cap when you replace it. That should be good enough to start.
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|