Farmall & IHC Tractors Discussion Board |
Re: Can HYD system oil can get back in to the eng
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Larry in GA on May 20, 2007 at 17:55:43 from (71.29.150.239):
In Reply to: Re: Can HYD system oil can get back in to the eng posted by El Toro on May 20, 2007 at 14:17:36:
El Toro Thanks for the parts break down it is a lot better than the one in the IT Manual El Toro you talked about a speedi-sleeve so the new seal has a new surface to rub on. you are referring to the drive shaft seal? With out tearing mine apart is there anything else that might not be in the kit that I will need. I hate to tear it down before finding out if they have what I need and then be down a week or more and at gas prices one trip is one to many. Thanks again for your help Larry
Replies:
Home
| Forums
Today's Featured Article -
Harvestin Corn in Southern Wisconsin: The Early Years - by Pat Browning. In this area of Wisconsin, most crops are raised to support livestock production or dairy herds in various forms. Corn products were harvested for grain, and for ensilage (we always just called it 'silage'). Silo Filling Time On dairy farms back in the 30's and into the first half of the 40's, making of corn silage was done with horses pulling a corn binder producing tied bundles of fresh, sweet-smelling corn plants, nice green leaves with ear; the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|