Farmall & IHC Tractors Discussion Board |
Delco 10SI Alternator -- shaft size
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Don LC on July 29, 2002 at 18:23:12 from (24.166.248.35):
I am changing my "M" over to 12v....I got every thing to do it execpt a smaller pully....Bob M,told me to use a 2" pulley or smaller...I removed the stock pulley,measured the shaft dia. as 5/8".I didn't think I was going to have to cut hairs!....They come 1/2" - 5/8" - 3/4",so I thought I had it made I bought a 1 3/4"dia. with a 5/8" bore....Too small!!!I ran a 5/8" drill bit through it,I cut a small amount of material out....still too small,I ran a 21/32"drill bit through it and it is still to small....The only one I could find had a key-way in it ,I can't cut too much because the key-way will cause the hole to move that direction, well that is what happened....Am I the only one that has run into this problem? What did you guy's do about getting a smaller pulley....thanks Don...
Follow Ups:
Home
| Forums
Today's Featured Article -
Oliver 550 Purchaser Checklist - by Greg Sheppard. Pound for pound the 550 is better than anything I've seen. It has great power for its size and can really hunker down and lug. Classified as a 3-bottom plow depending on soil conditions. I personally don't think it can be beat for a utility tractor in the 40 HP range. They are extremely thrifty on fuel, at least my DSL is. Most drive train parts are fairly easy to get. Sheet metal is probably the hardest thing to
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|