|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: steel wheel ranch rebuilt ta
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by paul on December 25, 2003 at 04:42:14 from (216.114.4.137):
In Reply to: Re: Re: Re: steel wheel ranch rebuilt ta posted by rebuilder on December 24, 2003 at 04:06:06:
Rebuilder.I'm working on a smta.Split was a sucess didnt drop it on my foot after removing seasonal disconnect plate I noticed that the previous owner or some hack welded the lever between the two bolt holes that secure enguaged or disenguaged didnt think to much about it at the time.After removal of ta housing I noticed that the same hack welded arround the ipto seasonal disconnect clutch hub,I would assume to lock it into drive because it worked fine using the hand control before split. will start to dissamble ta housing today and will let you know what I find.Paul.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
