Farmall & IHC Tractors Discussion Board |
Re: Tanner's 1944 H is ALIVE...Update
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan(VA). on March 14, 2005 at 08:09:01 from (66.82.57.47):
In Reply to: Tanner's 1944 H is ALIVE...Update posted by Tanner Clark on March 14, 2005 at 05:27:42:
Tanner and his wife are very pleasant people. It was an enjoyable trip and I'm glad I was able to help. I am sorry about the gas incident. I knew that you jumped and put the cap on the tank but I didn't realize that it got on you; as I was looking underneath at the filter and the sediment bowl. Sometimes I seem to get in a 'zone' working a problem and find I'm oblivious to anything else, my sincere apologies. I wasn't too concerned about leaving the final carb adjustments for you; after hearing about your work restoring some 4 cyl motor cycles that H should be a cake walk ;) All I did on the distributor was to set the cap in place to get a temporary visual point of reference for where the #1 tower was in relation to the base (Roughly 2:00 position, I just look for a paint chip or scratch that lines up), then take the cap back off and slowly pull the distributor with one hand until I can turn the rotor freely with the other. I spin the rotor up to the #1 point of reference I noted earlier and press the distributor back in and reinstall the clamp. You didn't miss much. I hope the fuel system flush and the wiring clean-up go well. You need to bring your wife over to see my H or M. With her experience (said she worked on hydraulic systems in college) you could get her excited about adding live hydraulics and a 3pnt hitch for you ;) See ya at some of the Summer shows if not earlier, Stan(VA).
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|