Farmall & IHC Tractors Discussion Board |
Re: 656 injectors
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Migraine on March 21, 2005 at 20:19:30 from (24.18.75.6):
In Reply to: 656 injectors posted by TWL on March 21, 2005 at 18:36:21:
The injectors on a 282 diesel can be stuck very tight but with a small pry bar and some penetrant they usually will finally break lose. Sometimes if you can get them to move horizontally a little bit first then they will come up out of there. Then put them on a pressure tester to check the spray pattern and if they have a dribble pattern they need new tips or total replacement. The ones last month for my 560 282 diesel cost 80 dollars each plus sending the old ones back . This was for rebuilt ones as new old stock are very hard to find. Make sure you change the washers down in the cups as well. Hope this helps. Migraine
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|