Farmall & IHC Tractors Discussion Board |
Super C light bar
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mike D on February 03, 2006 at 12:52:32 from (24.231.146.69):
Does any one know how to take the light bar out ,so i can check the wire harness for bar wires? Some welding had been done to the light bar on the left side to install a plate to put a starter switch on and i think they might of burnt the wire, as the lights keep burning out when hooked up to it. I did find two set screws for the light bar and took them out ,but i"m not sure if the bar comes out as one piece or two seperate pieces. I think it comes out in two pieces as there is two set screws,one for each side. So in short ,do they screw out or pull out as one piece or as two pieces????? Thank"s for any help. Mike
Replies:
Home
| Forums
Today's Featured Article -
Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|