Tom...

Posted by arod on July 03, 2006 at 12:03:49 from (130.20.51.229):

In Reply to: Re: H, transmission gear replacement... 1/2 way t posted by TomH in PA on July 03, 2006 at 10:36:20:

I removed the Unviversal joint, and that ONE center bolt in the shaft coupler going into the tranny. I imagine I just pull like the dickens and that bearing comes out.
Or must I remove the drive shaft COMPLETELY to allow enough room.

i.e. unbolt from the clutch side too. I don't want to do that if not necessary.

The bearing will slide out, I push the rod back a few inches, then pull out the top of the tranny cover, replace the roller bearing, slide on my new gears, and reverse the process?

Replies:

• Re: Tom... TomH in PA 13:41:04 07/03/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]