Farmall & IHC Tractors Discussion Board |
Re: Spliting An mM?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by zooeyhall on August 04, 2006 at 15:17:42 from (208.249.206.108):
In Reply to: Spliting An mM? posted by lala on August 04, 2006 at 15:04:35:
If it has the 11 inch clutch, you can replace the disk and pressure plate by taking out the hydraulic belly pump, and removing things through that opening. Very late model M's and Super M's have a 12 inch clutch. You can replace the disk on these without splitting, but if you want to replace the pressure plate you have to split the tractor. I am not sure at which serial number IH went from 11 inch to 12 inch clutch on the M, but I do know that it was very late in the model run.
Replies:
Home
| Forums
Today's Featured Article -
A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|