Farmall & IHC Tractors Discussion Board |
Re: a 57 year old rim...
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Wardner on September 11, 2006 at 11:23:00 from (4.154.245.207):
In Reply to: a 57 year old rim... posted by Pa. Pete on September 11, 2006 at 09:27:49:
I just repaired a rim like that on a tractor that is used alot a couple of weeks ago with fiberglass. It only took about 15 minutes and cost me next to nothing because I had some old resin and mat. Wire brush or grind the inside of the repair area several inches into good metal and apply 3-4 layers of cloth or mat. Put some masking or duct tape on the outside to keep the fiberglass from sagging through the holes. Sand the cured glass to remove any snags. Drill a new stem hole. Small amounts of glass and resin should be available at an auto parts, department, or marine store. A repair like that shouldn't require more than 3-4 ounces of resin and a square foot of mat/cloth.
Replies:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|