Farmall & IHC Tractors Discussion Board |
Re: Brushes in 300u starter
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob M on November 14, 2006 at 04:47:10 from (151.190.254.108):
In Reply to: Brushes in 300u starter posted by Jimer on November 13, 2006 at 16:54:10:
Jimer - 3 monkeys and a squirrel are not enough...you need at least one more squirrel(!) ---- Best way I've found is to make (4) "J" shaped hooks out of soft wire - #14 solid copper house wiring is about right. Before fitting the rear bearing cover to the starter frame, put one hook onto each brush holder, bending the hook as required so it holds the brush holder fully open. Next mount the end cover to the starter frame. Then insert the armature all the way into the frame. It should bottom easily against the end plate since the brushes are being held away from the commutator by the wire hooks. Finally after installing and tightening the (2) long thru bolts carefully remove the temporary hook from each brush holder thru the opening in the starter frame. The brushes will now be contacting the armature. ...Bob M
Replies:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|