Farmall & IHC Tractors Discussion Board |
Cub hydraulic repair
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by banjo on November 17, 2006 at 12:32:33 from (65.67.203.158):
I've been over on the cub forum and received some help. But I'll run it past ya'll. I took the block off and have it tore down and new 0-rings installed where i removed old ones.But i have 1 left over and connot find any place it could go. Plus i do not seem to have a releif valve or screen(cannot find where one was supposed to be).And the orifice screen seems to be MIA. Thee are the 0-rings i have replaced. 2-acuator seal ring, 2-piston seal rings, 1- piston head seal ring, 1- regulator valve seat, 1- regulator valve piston seal ring,1- control valve seal ring. My connecting rod yoke has a tapperd shaft so it did not have an 0-ring there but i still have 1 left for something else that i cant figure out. Did some of the cubs not have the releif valve plug and screen? there are no threaded holes under the bottom cover just the 3 allen head plugs.Thanks
Replies:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|