Posted by Patrick Martin on March 03, 2008 at 11:35:02 from (74.234.92.156):
Now I have another issue. I was cutting yesterday and verything was going just fine. I may have been cutting for maybe three or four hours, engine running perfect, govenor working perfect, etc.
I stop to disengage the PTO then as I release the clutch to move forward it died. I cranked and used the choke, etc, nothing.
Wait for a few minutes and the she fires up. hop on, put it in gear then let off the clutch and just as you heard the engine take the load it died.
Checked the valves, I'm still at .014" so thats good.
I checked to see if the timing looked right, rotated number 1 up to TDC on compression stroke, popped the cap, rotor is pointing to #1. Can't be timing I'd think, besides its a gear drive, I would have heard something before it konked out.
I pulled my distributor because I noticed about 3/8" rotational play back and forth. Looks like the pin that holds the gear has a little slack, not sheared but a little wiggle. I dont know if this is an issue but if so please let me know.
Could it be the valves not seating??????? I'm thinking of pulling the head and re-lapping the valves. Its a fresh head rebuilt by myself. All new valves and hardened seats. I'm thinking that maybe I didn't lap them well enough?????
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.