Posted by ScottyHOMEy on August 01, 2008 at 12:55:16 from (70.105.249.132):
In Reply to: Scotty... posted by Bob on August 01, 2008 at 12:29:37:
On the distributor, I agree. Trick is we don't know, and unless Bill set everything up to #1 TDC when he disassembled it, he may not know where the distributor is set to fire next, and I figured it might save him a whole lot of headache to have the rotor pointed at #1 from the gitgo, rather than have to wind the distributor all the way in the event, for example, that it was left ready to fire on #4.
On the mag, I also agree that it trips with the lug just about level across. When I go to remount and time a mag, though, I set it up to hold just before it trips on #1. I might have been clearer on that point in my response to Bill. As a result, the slot on the drive is pointed about 10 o'clock and 4 when viewed from the rear, and the lug on the mag at about 8 o'clock and 2. That way when I roll the mag away to trip the impulse, I only have to bring her around once to #4 to check before tightening her down.
My only aim was to leave Bill set up so that he would be as close as one could expect to having the ignition timed. On the distributor especially, I didn't want to leave him 180 out and scratchin' his head.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.